False position method

The false position method is a root-finding algorithm that uses a succession of roots of secant lines combined with the bisection method to approximate a root of a function f.

This page exists due to the efforts of the following people:

Timur

Timur

Karen Luckhurst

Created: 2014-06-25 09:50:21, Last updated: 2020-12-07 11:12:25
Creative Commons Attribution/Share-Alike License 3.0 (Unported)

This content is licensed under Creative Commons Attribution/Share-Alike License 3.0 (Unported). That means you may freely redistribute or modify this content under the same license conditions and must attribute the original author by placing a hyperlink from your site to this work https://planetcalc.com/3712/. Also, please do not modify any references to the original work (if any) contained in this content.

A brief false position method description can be found below the calculator

PLANETCALC, False position method

False position method

Digits after the decimal point: 4
Formula
 
The file is very large. Browser slowdown may occur during loading and creation.
x
 

False position method

False position method or 'regula falsi' method is a root-finding algorithm that combines features from the bisection method and the Secant method.

As in the secant method, we use the root of a secant line (the value of x such that y=0) to compute the next root approximation for function f.

The derivation of recurrence relation is the same as in the secant method:

Suppose we have starting values x0 and x1, with function values f(x0) and f(x1).
The secant line has the equation

\frac{y - f(x_1)}{f(x_1)-f(x_0)}=\frac{x - x_1}{x_1-x_0}

Hence the root of the secant line (where у=0) is

x = x_1 - \frac{x_1 - x_0}{f(x_1)-f(x_0)}f(x_1)

The above formula is also used in the secant method, but the secant method always retains the last two computed points, while the false position method retains two points that always bracket a root.
A graphical interpretation can be seen below.

Metodo_delle_secanti.gif

Source

As can be seen from the recurrence relation, the false position method requires two initial values, x0 and x1, which should bracket the root. But unlike the bisection method, the width of the bracket does not tend to zero with iterations.

The tolerance condition can be either:

f(x_k)< \epsilon — function value is less than ε.

\left|x_k-x_{k-1}\right| < \epsilon — difference between two subsequent хk is less than ε. Note that this is the difference between two calculated subsequent xk, not the end-points of the interval.

More: False position method

URL copied to clipboard
PLANETCALC, False position method

Comments